PSE-303操作说明书.pdfVIP

Setting Setting Procedures Initialize Keep pressing the button longer than two seconds. Remove the finger off the button when [Sor] is displayed and initialize can get started. 1.Display Color Setting Select a color for the LCD display. When changing the display color, press the or button to select a display color. Press the button to set the desired display color. 2.Output linked to display color Setting Select output linked to display color, press the or button and select output. Press the button to set. 3.Pressure Range Setting Select the pressure range suitable for the sensor connected. Press the or button and select the pressure range. Press the button to set. (Refer to the following table for the labels printed the units stuck on the display part) 4. Selecting Display Unit (In case [-M] is not assigned to unit specification in model indication) Refer to page 17, “Selecting Display Unit”. Unit Label How to use the labels printed the units In order to display the selected unit, the unit label according to the pressure range or the display unit is attached. •In case [M] is assigned to unit specification in model indication. Use the suitable label in the following labels by setup of the pressure range. LCD Display in0 in1 in2 in3 in4 in5 Unit Label kPa MPa kPa •In case [M] is not assigned to unit specification in model indication. Use the suitable label in the following labels by setup of the pressure range. LCD Display PA GF bAr PSi inH nnH 2 l For c