在有SCO UNIX光碟时,制作的方法：.doc

在有SCO UNIX光碟时，制作的方法： 1.Format a 3.5 inch high density diskette using the format(C) command. 2. mount -r /dev/cd0 /mnt 3.Change directory to the images directory: cd /mnt/images/boot NOTE: The example above assumes that your CD-ROM is mounted on the /mnt directory. If it is mounted on a different mount point, substitute that for /mnt in the example above. 4.Use dd(C) to copy the image to the diskette: dd if=image.img of=/dev/fd0 bs=18k image is the name of the image you want to copy. 5.Verify that the image was correctly written using sum(C): sum -r /dev/fd0 Compare the result to the checksum file in /mnt/images/boot that corresponds to the image you copied. 在DOS制作的方法： Use the floppycp command to copy the image to the diskette: D:\images\floppycp \f D:\images\boot\image.img image is the name of the image you are copying. 下面是源光碟上的介绍。。。。。。。 Creating the Installation Boot Diskette: To create the installation diskette under UNIX, take the following steps: 1. Format a 3.5 High Density Diskette using the Unix format(C) command. Label the diskette SCO OpenServer Release 5.0.5 Install Disk. 2. Change directory to the images directory: cd /mnt/images NOTE: The example above assumes that your CDROM is mounted on the /mnt directory. If it is mounted on some other mount point, substitute that for /mnt in the example above. 3. Use the ezcp command to copy the image to the diskette: ./ezcp boot/install.img 4. Verify that the image was correctly written using the Unix sum(C) command: sum -r /dev/fd0 and compare it to the correct checksum, which is stored in install.sum NOTE: Depending on the version of your operating system and the configuration of your hardware, you may use a device node other than /dev/fd0. 制作SCO UNIX 5.0.x的安装软盘 在DOS，或者WIN下的制作方法 To create the installation diskette under MS-DOS, take the following steps: 1. Format a 3.5 High Density Diskette using the DOS format command. Label the diskette SCO OpenServer Release 5.0.5 Instal