EIGRP路由协议配置实验.doc

一、实验目的 掌握EIGRP的配置 掌握EIGRP负载均衡的配置 掌握EIGRP中地址的手工汇总 二、实验内容实验。 三、实验环境实验使用的设备名称及规格 3台 四、实验过程与分析 根据实验记录整理。详细记录在实验过程中发生的故障和问题，进行故障分析说明故障排除的过程及方法。R1： F0/0 RouterEN Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface F0/0 Router(config-if)#ip address 21.21.21.1 255.255.255.0 Router(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up Router(config-if)#exit S0/2/0 Router(config)#int s0/2/0 Router(config-if)#ip address 12.12.12.1 255.255.255.0 Router(config-if)#clock rate 64000 Router(config-if)#no shut %LINK-5-CHANGED: Interface Serial0/2/0, changed state to down Router(config-if)#exit Lo1 Router(config)#int lo1 Router(config-if)#ip address 1.1.1.1 255.255.255.0 Router(config-if)#no shut R2： F0/0 Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#int f0/0 Router(config-if)#ip address 21.21.21.2 255.255.255.0 Router(config-if)#no shut %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config-if)#exit S0/2/0 Router(config)#int s0/2/0 Router(config-if)#ip add 12.12.12.2 255.255.255.0 Router(config-if)#no shut %LINK-5-CHANGED: Interface Serial0/2/0, changed state to up S0/2/1 Router(config)#int s0/2/1 Router(config-if)#ip add 23.23.23.2 255.255.255.0 Router(config-if)#clock rate 64000 Router(config-if)#no shut %LINK-5-CHANGED: Interface Serial0/2/1, changed state to up Router(config-if)# %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/2/1, changed state to up Lo1 Router(config)#int lo 1 Router(config-if)# %LINK-5-CHANGED: Interface Loopback1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback1, changed state to up Router(config-if)#ip add 2.2.2.2 255.255.255.0 Router(config-if)#no shut Router(config-if)#exit R3： S0/2/0 Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(con