塔式吊车安全介绍.docVIP

起重机与提升设备 Ⅳ. Cranes and Lifting Equipment 起重机可分为固定式起重机及移动式起重机： Cranes can be divided into stationary and mobile Cranes 一、固定式起重机(塔式吊车)介绍： 1. Instruction of Stationary Crane (Tower Crane): 塔式吊车基件介绍 详图十二 Introduction of Tower Crane Components (see Fig. 12.) 塔式吊车安装 详图十三 Installation of Tower Crane (see Fig. 13) 塔式吊车爬升 详图十四 Ascending of Tower Crane (see Fig.14) 塔式吊车拆除 详图十五 Disassembly of Tower Crane (see Fig. 15) 二、移动式起重机 详图十六 2. Mobile Crane (see Fig. 16)   1 圖十三 塔式吊車安裝 Fig. 13: Installation of Tower Crane 材料進場 Material Arrival S1：安全設施準備 Preparation of safety facilities. S2：材料吊運安全檢查 Material lifting safety inspection. 塔吊底座安裝 Tower Crane Base Installation S3：構架安全檢查 Strucrual Frame Safety Inspection. 塔節安裝 Tower Section Installation 爬升籠安裝 Ascending Cage Installation 旋轉盤及駕駛座組裝 Revolving Panel and Operation Seat Assembly A座安裝 Seat A Installation 後椼架地組 Rear Truss Ground Unit 後椼架安裝 Rear Truss Installation 1/2配重塊安裝 1/2 Counterweight Installation 前椼架地組 Front Truss Ground Unit 前椼架安裝 Front Truss Installation 安全裝置安裝 Safety Device Installation 電纜線安裝 Cable Installation 試車及載重試驗 Test Run and Load Test 安裝作業完成 Installation Work Completed S6：檢查機構檢查 Inspection Unit Check 檢查合格候使用 Use after passing the Inspection S1：1. 安衛及鋼構組配作業主管須在場 Safety and Steel Structure Assembly Supervisor must present at the site. 2. 吊掛作業人員需佩帶安全帶、安全帽 The lifting workers must put on safety belt and helmet. 3. 安全母索、安全網準備 Prepare safety belt and safety net. S2：1. 起重機操作手、吊掛手、指揮手須接受合格訓練 Crane operator, hoisting operator and directing person must accept the required training. 2. 材料需放置整齊 Materials must be arranged trimly. 3. 吊物下方禁止人員進入 No person is allowed to stand under the hoisted object. 4. 移動式起重機合格證 Mobile crane certificate required. S3：1. 零件、螺栓集中放置 Store parts and bolts in one place. 2. 手工具要繫於腰際 Tie the hand tools on the waist. 3. 座樑補強確認 Confirm the girder reinforcement. 4. 高度超果二公尺時要設置爬梯、安全母索、安全網等安全措施 If the height is over 2 meters, the ladder, safety belt and safety net must be installed. 5. 部接合螺栓穿鎖檢查 Check