CASE解法中文版.docVIP

CCNP642 - 892 CASE解法中文版 作者：宋小颂 来源： Hotspot?1 : super?HSRP question 热点1： HSRP的问题 - DS1( Distribute switch 1)?is the primary device for Vlan 101, 102, 105 - DS1的（1）是，主要设备的VLAN 105 101 102 -?DS2 ( Distribute switch 2)?is the primary device for Vlan 103 and 104 - DS2的（2）是主要的设备和104 103的VLAN Question 1: 问题1： During routine maintenance, it became necessary to shutdown G1/0/1 on DS1. 在日常维护，它成为必要关闭G1/0/1端口。 All other?interface were up. 所有其他接口增长。 During this time, DS1 remained the active device for Vlan 102s HSRP group. 在此期间，DS1的仍然是VLAN 102的HSRP组有源器件。 You have determined that there is an issue with the decrement value in the track command in Vlan 102s HSRP group. 你有决心，有一组发出的HSRP的减量赛道价值命令在VLAN 102。 What need to be done to make the group function properly ? 需要做什么，以使本集团正常运行？ The DS1s decrement value should be configured with a value from 5 to ：DS1的的递减价值应配置5至15B. The DS1s decrement value should be configured with a value from?9 to 15 DS1的衰减值应配置从9到15 C. The DS1s decrement value should be configured with a value from?11 to 18DS1的减量值应该是配置了一个由11至18 D. The DS1s decrement value should be configured with a value from 195 to less than 205D:DS1的的减量值应该是配置了一个195的值205 E. The DS1s decrement value should be configured with a value from?200 to less than 205EEEE DDDS1的减量值应该是配置了200的值205 F. The DS1s decrement value should be greater than?190 and less?200F的DS1的减量值应大于190，少200 Explanation: 说明： Use show run command to show.使用“”命令来显示。 The left Vlan102 is console1?of DS1.左Vlan102是DS1的控制台。 Priority value is 200, we should decrement value in the track command from 11 to 18.优先级值是200，我们应该在轨道命令递减值从11到18岁。 Because 200 - 11 = 189 190 ( priority of Vlan102 on DS2 ).由于200 - 11 = 189 190（DS2的Vlan102对优先级）。 Question 2: 问题2： During routine maintenance, G1/0/1 on DS1 was shutdown. 在日常维护，G1/0/1对DS1的是关机。 All other?interface were up. 所有其他接口增长。 DS2 became the active HSRP device for Vlan101 as desired. DS2的HSRP的装置Vlan101成为活跃的到位。 However, after G1/0/1 on DS1 was reactivated. 然而DS1的，就被激活后G1/0/1。 DS1 did not