外文翻译--汽车服务的设备.doc

附录B2外文文献 Automobile Servicing Equipment TranX2000rM is an effective and flexible tool for servicing automatic transmissions. The unit is portable and car be used both in the vehicle and on the bench. The TranX has been designed with a microprocessor, which gives it the capability to hold information to drive and analyze all transmission types. As new transmissions come onto die market the tranX design allows simple periodic upgrades with a single plug in device. This device is accessible al the back of the TranX2000? controller and can be replaced quickly. Please take a moment to register your TranX2000 so the producer can notify you as updates become available. The TranX2000 has two main components, thy controller and the interface box. All the electronic switches, solenoid drivers and measurements, electronics are located in the interface box. This was done so all the electronic components of the TranX would be closer to the electronic solenoids they are controlling. You can plug your power cord into either the controller or the interface box to provide power to the TranX. Whenever possible, the producer recommends using the interface box, along with the battery adapter cahle in your kit, to power up the TranX. Be sure to run the black clip to battery ground and the red clip to battery 12 volts. Each TranX2000? dedicated harness set consists of two cables. One connects to the vehicle transmission and the other to the vehicles ECU harness. Both these adapters attach to the interface box. You only need to use the transmission side adapter if you are working on the bench. To prevent user error, all FXU (harness) side cables have male pins, all transmission sides cables have female pins. Dedicated harness sets are listed on the transmission test sheets, along with connector drawings and wire charts. Original equipment connectors are used whenever possible and new harness sets are constantly being offered. If you need a connector set that the producer does not offer at