两种木质刨花模压工业托盘技术特点的比较.pdfVIP

两种木质刨花模压工业托盘技术特点的比较 1 2 李大纲 ，李苏杨 ( 1.南京林业大学木材工业学院，南京，210037 ；2..江苏泗阳蓝阳制造有限公司, 泗阳, 223700) Comparison of Two Kinds of Properties of Molded Wood Particle Board Pallets 1 2 Li Dagang , Li Suyang (1. College of Wood Science and Technology , Nanjing Forestry University , Nanjing 210037 , China ; 2. Jiangsu Siyang Lan Yang Pallets Co. Ltd, Siyang 223700, China ) 摘要:本文讨论了由德国迪芬巴赫公司设计制造的人造木材成型(FORMWOOD) 设备生产的巢式(凹凸型) 刨花模压托盘与中国江苏蓝阳托盘制造有限公司研制的平面刨花模压工业托盘的技术特点。这两种托盘均 采用木材加工废弃物，回收废旧木材或其它木质纤维原料生产，并均可重新打碎后，循环利用。符合许多 国家在进口货物时所要求的国际贸易木制包装材料准则(ISPM15)的要求。含水率低于6－8%，不用铁钉和螺 钉联接，一次模压成型，从而提高了托盘的抗破坏能力。不需要进行熏蒸处理和其它化学处理即可出口。 迪芬巴赫公司的产品采用巢式结构作为托盘增强结构，表面凹凸不平整，叠加堆放可减少50%的存放空间。 江苏蓝杨托盘厂生产的是平面托盘，板面平整，可用于有平面要求（如纸张等）的堆放，可在中间添加竹 片以增加托盘强度，支撑脚是直径10cm，壁厚2.5cm的圆柱形直脚，强度大，稳定性好。这两种形式的模压 托盘均具有各自的专利技术，均采用回收或废旧植物纤维为原料，不仅在性能上优于传统的实木托盘，而 且价格和重量也均低于传统的实木托盘。 关键词：刨花模压托盘；特性；迪芬巴赫公司；蓝阳托盘厂 Abstract: This paper discussed the molded particle board pallets properties of German Dieffenbacher Company produced and China Lan Yang Company produced. The products of both company process turns damaged logs, wood waste, and other wood by-products into new molded particle board pallets which can be recycled. Pallets conform with ISPM 15 (International Standard for Phytosanitary Measures). Low moisture content (6-8%) reduces risk of product damage. No nails or screws to cause damage or injury. No heat or chemical treatments for exports. But the Pallet of Dieffenbacher Company is nest encourages return trips, Reduces storage space by over 50%. Lan Yang Company is the surface flat pallet, inside using bamboo strip reinforce pallets. Rounded legs corners improve strength. So, both of two kinds