X轴电机控制线的更换.xls

5040103 ????????X交換 ????表紙原紙 Machinery Part Replacement Hold the cable bearer. Open the cover of the cable bearer. Apply silicone grease to the cables and the cable bearer. Silicone grease Lock the cable bearer with the cable ties put through the plate in Step 12. Item No, 登録日 登録者 田原 総?????数 要約 Tick ００６ ００５ ００４ ００３ ００２ Ver. No. 年?月?日 改訂者 検印 TIR05001-04B 項 目 (本状含む） 資料/????　格納先 記事 （改定理由、関係書類等） CM402-E-M-052-001 X-axis Cable Bearer Replacement 8????? □写真 □???? □その他（ ） X-axis Unit 5-3-3　　　　　 X-axis Cable Bearer Replacement This section describes the procedures for replacing the X-axis cable bearer. 　 Be very careful that the cables are not strained excessively or caught. ?Tools Phillips screwdriver #1 Flat blade screwdriver #1 Allen key (Long) 5 mm Nipper Ruler 150 mm or 300 mm ?Jig None X-axis Unit Item Remarks Switch off the main power. Turn the switch to the left. Remove the top cover from the head assembly. Phillips screwdriver #1 Round cross-head screw 4 pcs. Remove the head connectors, the blow tube and the vacuum tube. Connector numbers: 1,2, 8, 9 and 11 Remove the cable tie from the cables. Cut the cable tie off from the cables. Nipper Cable tie 150 1 pc. Cut the cable ties off from the cable bearer. Nipper Cable tie 150 4 pcs. Remove the cable bearer holding bolts. Allen key 5 mm Screw M6 4 pcs. Be careful not to strain the cables excessively. Flat head screwdriver #1 Remove the cable bearer holding metal plates from both ends of the cable bearer. Flat head screwdriver #1 Remove the cable bearer. Check that the cable bearer consisits of the 12 parts as shown below: Nipper Cable tie 150 4 pcs. Put cable ties through the holes of the cable bearer holding plate. Cable ties Place the cable bearer in position. Take care with orientation: the end with a bump should be positioned on the upper side and the other end (with a hollow) should be positioned on t