《Module 7 - Setting Up for Transfer to PCB and Importing Data》.pdf

Module 7: Setting Up for Transfer to PCB and Importing Data Module 7: Setting Up for Transfer to PCB and Importing Data 7.1 Setting Up for Transfer to PCB 7-1 7.1.1 Setting the relevant project options 7-1 7.1.2 Transferring a design to the PCB Editor 7-1 7.1.3 Netlist formats 7-2 7.1.4 Design transfer using a netlist 7-2 7.1.5 Exercise – setting project options for design transfer 7-3 Software, documentation and related materials: Copyright © 2009 Altium Limited. All rights reserved. You are permitted to print this document provided that (1) the use of such is for personal use only and will not be copied or posted on any network computer or broadcast in any media, and (2) no modifications of the document is made. Unauthorized duplication, in whole or part, of this document by any means, mechanical or electronic, including translation into another language, except for brief excerpts in published reviews, is prohibited without the express written permission of Altium Limited. Unauthorized duplication of this work may also be prohibited by local statute. Violators may be subject to both criminal and civil penalties, including fines and/or imprisonment. Altium, Altium Designer, Board Insight, Design Explorer, DXP, LiveDesign, NanoBoard, NanoTalk, P-CAD, SimCode, Situs, TASKING, and Topological Autorouting and their respective logos are trademarks or registered trademarks of Altium Limited or its subsidiaries. All other registered or unregistered trademarks referenced herein are the property of their respective owners and no trademark rights to the same are claimed. Module Seq = 7 7.1 Setting Up for Transfer to PCB This section outlines how to transfer a schematic design to the PCB Editor using the Synchronizer or a netlist. 7.1.1 Setting the