机电工程专业英语 朱晓玲 Lesson 12新.pptVIP

Lesson 12 THE OPERATION PANEL数控铣床控制面板操作 Section I Words and Phrases Section II Text and Translation Section III Exercises and Answers End Next Section I Words and Phrases emergency [i5mE:dVnsi] n.紧急情况, 突然事件, 非常时刻, 紧急事件 rotation [rEu5teiFEn] n.旋转 overload[5EuvE5lEud] vt.使超载, 超过负荷 n.超载, 负荷过多 eliminate [i5limineit] vt.排除, 消除 v.除去 manual [5mAnjuEl] n.手册, 指南 adj.手的, 手动的 collision [kE5liVEn] n.碰撞, 冲突 execution [7eksi5kju:FEn] n.实行, 完成 transfer [trAns5fE:] n.迁移, 移动 Topic Above Next End Section I Words and Phrases position [pE5ziFEn] n.位置, 职位 correspond [kCris5pCnd] vi.符合, 协调 multiplier [5mQltiplaiE] n.增加者, 增效器, 乘法器 capability [7keipE5biliti] n.能力，性能，容量 cancellation [kAnsE5leiFEn] n.取消 override [7EuvE5raid] vt.制服 monotonous [mE5nCtEnEs] adj.单调的, 无变化的 traverse [5trAvE(:)s] n.横贯 vt.横过, 在...来回移动 Topic Above Next End Section I Words and Phrases MDI (manual data input) 手动输入数据 single execution 单步执行 DRN (dry run) 空运行 MLK（machine lock）机床锁定 SBK（single block）单程序段 OPS（optional stop）选择停 with respect to 谈到 control panel 控制面板 Topic Above Next End Section I Words and Phrases feed rate override 进给修调 rapid traverse override 快速修调 feed hold 进给保持 cycle start 循环启动 manual pulse generator 手摇脉冲发生器 Topic Above Next 汉 End Section II Text Following Fig.3-5 is a control panel. Fig3-5 control panel Topic Above Next 汉 End Section II Text 1.EMERGENCY STOP The EMERGENCY STOP button is red and is located in the lower left corner of the control panel. If this button is pressed, the feed and rotation of the tool is stopped and the control system of the computer is turned off. The EMERGENCY STOP button is only used in special situations. Some of these are the overloading of the machine, a machined part is loose, or incorrect data in the program are causing a collision between the tool and the work-piece1. To reset the EMERGENCY STOP button, push it in and turn it clockwise. Then you can turn the machine