LTE eNodeB V2.1调测.ppt

* * * * When ALD connected to RET port ,please use MOD RETPORT , When ALD connected to TX/RXA port , please use MOD ANTENNAPORT. 当ALD连接到电调天线接口时，请使用MOD RETPORT命令，当ALD连接到TX/RXA接口是，请使用MOD ANTENNAPORT. * 如果以前没有下载MML文件，设备需要首先增补MML文件，否则部分MML命令无法在LMT上执行。 * * * * * ETHER: Ether Header ETHER: ETHER: Packet 79 arrived at 15:39:40.44936 ETHER: Packet size = 350 bytes ETHER: Destination = ff:ff:ff:ff:ff:ff, (broadcast) ETHER: Source = 0:9:10:9:18:32, ETHER: Ethertype = 0800 (IP) ETHER: IP: IP Header IP: IP: Version = 4 IP: Header length = 20 bytes IP: Type of service = 0x00 IP: xxx. = 0 (precedence) IP: ...0 = normal delay IP: 0... = normal throughput IP: .0.. = normal reliability IP: ..0. = not ECN capable transport IP: ...0 = no ECN congestion experienced IP: Total length = 336 bytes IP: Identification = 23 IP: Flags = 0x0 IP: .0.. = may fragment IP: ..0. = last fragment IP: Fragment offset = 0 bytes IP: Time to live = 255 seconds/hops IP: Protocol = 17 (UDP) IP: Header checksum = ba86 IP: Source address = , OLD-BROADCAST IP: Destination address = 55, BROADCAST IP: No options IP: UDP: UDP Header UDP: UDP: Source port = 68 UDP: Destination port = 67 (BOOTPS) UDP: Length = 316 UDP: Checksum = 28B2 UDP: DHCP: Dynamic Host Configuration Protocol DHCP: DHCP: Hardware address type (htype) = 1 (Ethernet (10Mb)) DHCP: Hardware address length (hlen) = 6 octets DHCP: Relay agent hops = 0 DHCP: Transaction ID = 0x1c7cb DHCP: Time since boot = 0 seconds DHCP: Flags = 0x8000 DHCP: Client address (ciaddr) = DHCP: Your client address (yiaddr) = DHCP: Next server address (siaddr) = DHCP: Relay agent address (giaddr) = DHCP: Client hardware address (chaddr) = 00:09:10:09:18:32 DHCP: DHCP: (Options) field options DHCP: DHCP: Message type = DHCPDISCOVER DHCP: Vendor-specific Options (26 total octets): DHCP: (170) 170 octets 0x08 0x01 0x01 0x14