axxicon模具.pdfVIP

AIM Information Booklet The AIM Mould System is a product of: Axxicon Moulds Eindhoven BV Ekkersrijt 7501 5692 HN Son P.O. Box 1717, 5602 BS Eindhoven The Netherlands Tel. +31-499-494 450 Fax +31-499-461 361 Email: eindhoven@ A member of the Mikron Technology Group AIM Information Booklet PREFACE This booklet is made to inform you about the AIM Mould System and the relationship between ISO, ® CAMPUS and Axxicon Moulds Eindhoven BV. You will find information on the latest developments in testing polymer properties and the reasons why every laboratory should have an ISO mould, like our AIM Mould System. At the end the importance of a good and experienced mould maker is explained. A mould maker who is trusted by all main plastic testing laboratories in the world. Note: This and other information is also available on Axxicon Moulds Eindhoven BV operates in a policy of continuous development. Therefore we reserve the right to make changes and improvements to any of the products described in this booklet without prior notice. Axxicon Moulds Eindhoven BV cannot be held responsible for any kind of damage caused by the information in this booklet. No part of this book may be reprinted or reproduced without permission by Axxicon Moulds Eindhoven BV. ® The information is partly taken out of information from ISO and CAMPUS , but may contain not updated information or mistakes. ® Therefore we advise you to check everything with relation to ISO and CAMPUS yourself. ® ® CAMPUS is a registered trademark of CWFG, Frankfurt am Main, Germany TM AIM is