S+Rack_PCU_CN.ppt

* * * * Redundant BRC410’s use same RCL Cable as BRC300/400 RCL Cable is the small ribbon cable that connect to module faceplate BRC410 also supports RS232 / 485 interfaces thru use of the following additional hardware : PBA: Process Bus Adapter provides cable connection to module NKTU01 or NKTU11 cables from PBA to TPM01 This is identical to the connections for BRC300/400 Note: Next version of GPI Software (version 4.0) will offer serial connectivity software suite for use with BRC410. General Purpose Interface or GPI Software is a system integration products to seamlessly interface Harmony Control Systems to many types of control and monitoring systems via RS232 communication. Harmony Gateway Software or HGS was derived from GPI but, is a separate software package specifically designed for ModBus TCP interface applications on the BRC410 hardware platform. * Harmony Gateway Software (HGS) has been enhanced to: Support MODBUS “Client” or “Server” mode communication HGS supports “Client”, “Server”, or “Client/Server” Enables BRC410 to communicate with any ModBus TCP device Support same # of MODBUS points: 500, 1500, 3000, or 4000 are supported Optionally supports redundancy (if supported by 3rd party) Redundancy is managed by BRC410 only for connections where BRC410 is the “Client” * The Ethernet connection on the faceplate of the BRC410 is a standard RJ45 connector BRC410 Ethernet output supports Copper Link, CAT5 or better media Supports a maximum distance of 100 meters However, using standard Network hardware greater distances can be supported Document 3BSE046579 identifies the list 3rd party network hardware that is tested with 800xA * 北京 系统介绍： 模拟输入子模件 Analog Input Slave Module SPFEC12模件具有的LED： 模拟输入子模件 SPFEC12 NTAI05 端子单元的配置 模拟输入子模件 SPFEC12 Analog Input Module SPFEC12 系统介绍： 模拟输出子模件 Analog Output Slave Module SPASO11模件具有的Output通道： ASO TDI KTU ? 模拟输出：14个高电平标准信号 1~5VDC、4~20mA D/