Juniper业务开通手册.doc

Juniper 业务开通手册 - ＺＴ 2007年12月02日 星期日 05:42 管理员手册-JUNIPER设备 XXXXX公司二ΟΟ六年八月 目录1.??? 总体概述??? 32.??? 路由器CLI??? 43.??? 路由器基本配置??? 104.??? 端口配置??? 135.??? 协议独立路由属性的配置（静态路由，汇聚路由，本地AS号码，ROUTER-ID等属性）??? 186.??? 配置IS-IS路由??? 197.??? 配置OSPF路由??? 218.??? 配置BGP路由协议??? 229.??? 配置MPLS和LDP??? 2410.??? 配置LDP OVER RSVP(仅核心节点)??? 2511.??? 配置MPLS快速重路由(仅核心节点)??? 2612.??? 配置MULTIPROTOCOL BGP??? 2713.??? 配置MPLS VPN功能??? 2814.??? 配置CLASS-OF-SERVICE??? 30 1.??? 总体概述本文档为XX公司编写。用于说明Juniper设备在XXX网络使用到的基本命令。所有命令是基于JUNOS 7.2的。更多的信息请参考下面的网站：Juniper：/techpubs/software/junos/junos72/index.html 2.??? 路由器CLI设备启动信息应先将CONSOLE线接到设备CONSOLE口, 打开笔记本电脑, 启动超级终端软件, 然后打开路由器电源开关, 几秒钟之后, 超级终端界面会出现类似如下的启动界面: Award Modular BIOS v4.51PG, An Energy Star AllyCopyright (C) 1984-98, Award Software, Inc. TEKNOR APPLICOM T1023 BIOS Version 1.2 DWD 11/29/2000-i440BX-SMC67X-2A69TU00C-00 PXE-M04: Initializing network boot device using interrupt 18h..... PXE-M04: Initializing network boot device using interrupt 18h..... PXE-M04: Initializing network boot device using interrupt 19h..... Intel LANDesk (R) Service Agent II, version 0.99kCopyright (C) 1997,1998?? Intel Corporation. All rights reserved. PXE-E67: Invalid MAC address.????????????????????????????????????????????????? PXE-M0F: Exiting LANDesk (R) Service Agent II Will try to boot from :PCMCIA ATA Flash CardCompact FlashPrimary IDE Hard DiskEthernet Trying to Boot from Compact FlashLoading /boot/loaderConsole: serial portBIOS drive A: is disk0BIOS drive C: is disk1BIOS drive D: is disk2BIOS 639kB/785344kB available memory FreeBSD/i386 bootstrap loader, Revision 0.8(builder@, Tue Oct 5 00:09:53 GMT 2004)Loading /boot/defaults/loader.conf /kernel text=0x4c26d1 data=0x2c8bc+0x49f34 syms=[0x4+0x41710+0x4+0x4d988] Hit [Enter] to boot immediately, or space bar for command prompt.Booting [kernel]...?????????????? Copyright (c) 1996-2001, Juniper Networks, Inc.All rights reserved.Copyright (c) 1992-2001 The FreeBSD Project.Co