课程设计工卡.doc

A/C REG 机号 REV.DATE 修正日期 TITLE 标题 Engine Oil Quantity is High 发动机滑油量高 CARD NO 卡号 1 2011-11-27 Z76-CA-101-1 Item 工序 Job Description 工作单内容 MECH 工作者 INSP 检查者 TASK 79-05-00-810-808-F00 任务 79-05-00-810-808-F00 A：Possible Causes 可能原因 1 Oil indication failure 滑油指示故障 2 Oil Quantity Transmitter, M213 滑油流量传感器故障 3 Fuel in the oil due to: 燃油进入滑油，由于： a Main Oil/Fuel Heat Exchanger inter-circuit leakage 主滑油/燃油热交换器内回路泄露 b Servo-Fuel Heater inter-circuit leakage. 伺服燃油加热器内回路泄露 4 Oil system overservicing due to oil retention. 由于滑油滞留，导致滑油系统提供过多滑油 B： Fault Isolation Procedure 故障隔离程序 1 Open the applicable access doors on the right fan cowl panel. Number Name/Location 打开的风扇罩面板。号码名称/位置414AR Oil Tank Access Door, Engine 1 414 ar油柜检修门、发动机1424AR Oil Tank Access Door, Engine 2 414 ar油柜检修门、发动机1 2 Compare the oil level at the oil tank sight gage with the oil quantity display on the center DU.比较油位在油舱视力计与油量 A/C REG 机号 REV.DATE 修正日期 TITLE 标题 Engine Oil Quantity is High 发动机滑油量高 CARD NO 卡号 2 2011-11-27 Z76-CA-101-1 Item 工序 Job Description 工作单内容 MECH 工作者 INSP 检查者 a If the oil level in the sight gage agrees with the oil quantity display on the center DU, then do the steps below for the oil level through the sight gage is high . 如果油位在视力计油量显示在中心DU做下面的步骤油位通过视力计是高 b If you can not see the oil level in the sight gage, then add engine oil to the oil tank. 如果你不能,那么添加机油油舱。1 Do this task: Replenish the Engine Oil, AMM TASK 12-13-11-600-801. 做这个任务:补充机油,AMM任务12-13-11-600-801。 c If the oil level in the sight gage does not agree with the oil quantity indication, then 如果油位在视力计该油量指示,那么 3 Do these steps to examine the electrical power at the Oil Quantity Transmitter, M213: 做这些步骤来检查电力在油量传感器,M213:For the applicable engine, open these circuit breakers: 找到有问题的发动机，打开这些断路器 CAPT Electrical System Panel, P18-2 Row Col Number Name 电子系统面板章节，P18-2，行列编号; D 5 C01359 DISPLAY DEU 1 PRI F/O Electrical System Panel, P6-1 Row Col Number Name D 9 C01362 DISPLAY DEU 2 HOLDUP D 10 C01361 DISPLAY D