STK10与Matlab互联(STK10破解).docxVIP

QQ：2335298917由于STK10以后，STK10与matlab互联需要安装connector，网站上只有32bit版本，因此将32bit connector下载下来并安装。网站介绍如下：MATLABConnectors Setup andInstallationMATLAB Interface setupStarting with STK 10, connectors are required to run AGI M-files and MEX files. STK MATLAB connectors simplify the setup of the MATLAB Interface by automatically configuring the MATLAB file path for a specific MATLAB version. For each supported version of MATLAB, AGI produces a connector, which can be downloaded from the link below:32-bit connectorInstallation instructions?for the MATLAB Connectors.Supported MATLAB versionsThe following versions of MATLAB are supported in STK 10: 2008a,?2010a, 2010b, 2011a, 2011b, 2012a, 2012b, 2013a.由于支持的matlab版本原因，我选择了matlab2011b32bit进行连接。安装顺序，先安装matlab2011b，再安装STK10，最后安装connector。STK10与matlab互连的设置步骤将“STK安装目录\bin\Matlab”文件夹中的“agiCleanPath.m”、“agiInit.m”、“stkInit.m”复制到“Matlab安装目录\toolbox\local”文件夹中；启动matlab和stk，将matlab当前目录设为“STK安装目录\bin\Matlab”，在matlab中运行指令“stkInit”。显示如下： stkInitSTK MATLAB Interface: Loaded API at d:\Program Files (x86)\MATLAB\R2011b\bin\win32.Warning: mexConnect: Connecting to localhost:5001这样，matlab与STK10就连接好了，可以在matlab中进行各种命令的发送和设置，stk10会有相应的动作。以《STK在计算机仿真中的应用》第21章的例子为例，运行结果如下：将例子代码和文件放到D盘根目录下，并把D盘根目录加入matlab的path中，在matlab中运行STKTest，结果如下： STKTestCreate a new scenarioSet scenario time periodCreate a leidazhan1Create a hangfangleida1 radarCreate a leidazhan2Create a haifangleida2 radarCreate a new missleans =doubleCompute the local horizontal-referenced elevation angle ...Compute a long range air intercept missile trajectory...Create an external state file and tell STK to load it.图形如下：STK10场景如下：QQ：2335298917附录：MATLAB Interface to STK Setup GuideThis guide provides instructions for setting up the interface between MATLAB and STK 10.PrerequisitesA supported version of MATLAB installed (Check?/matlab?for a list of MATLAB versions supported by STK 10.)STK 10 installedSTK Integration licenseA valid STK-MATLAB configuration. For diagrams of valid 32-bit and 64-bit