（HSE管理文件）FREP-04-HSE-2022.doc

福建项目ROJECT CONSTRUCTION 载人升降机程序 PERSONNEL HOISTING PROCEDURE 文件编号DOCUMENT NUMBER: FREP-04--2022  载人升降机程序 PERSONNEL HOISTING PROCEDURE 目录Table of Contents 编号NO. 页码page 1.0 目的PURPOSE 3 2.0 范围SCOPE 3 3.0 定义DEFINITIONS 3 4.0 职责RESPONSIBILITIES 3 5.0 指导说明INSTRUCTIONS 4 6.0 参考资料REFERENCES 11 7.0 附件ATTACHMENTS 11  1.0目的PURPOSE The purpose of this Procedure is to establish the minimum requirements for the use of personnel hoisting platforms 2.0 范围SCOPE the use of personnel hoisting platforms in FREP project. 3.0 定义 DEFINITION —拒载，破坏或构件分离。 Failure—load refusal, breakage, or separation of components. 3.2 升降（或升降机）—起重机的所有功能例如：降低，提升，回转，搭（拆）浮桥上下或者悬吊载人平台。 Hoist (or hoisting)—all crane or derrick functions such as lowering, lifting, swinging, booming in and out or up and down, or suspending a personnel platform. 3.3 拒载—超过极限强度的载荷。 Load Refusal—the point where the ultimate strength is exceeded. 3.4 最大预定载荷—所有员工、工具、材料的总负载和其它任意时刻施加于载人平台或载人平台构件的预期载荷。 Maximum Intended Load—the total load of all employees, tools, materials, and other loads reasonably anticipated to be applies to a personnel platform or personnel platform component at any one time. 3.5 防脱钩绳—在起重机吊钩开口处使用金属丝束紧。 Mousing—using wire to close the crane hook opening. 3.6 跑道—坚固的水平表面设计和布置，并指定作为使用起重机悬吊