建设工程安全生管理条例试题及答案.doc

建设工程安全生产管理条例?施工单位主要负责人依法对本单位的安全生产工作（ ）。 A．B．全面负责。 C．A．B．C．A．B．C．A．B．全面负责。 C．A．B．安全员 C．。A．B．15日 C．A．B．每季度 C．A．B．作业人员 C．。 A．B．3年 C．、A．B．C．。 A．B．C．A．B．C．A．B．C．??违反建设工程安全生产管理条例的规定，施工单位使用未经验收或者验收不合格的施工起重机械和整体提升脚手架、模板等自升式架设设施的，责令限期改正；逾期未改正的，责令停业整顿，并处（ ）的罚款。 A．B．C．A．B．C．A．B．二万元以上五万元以下 C．A．B．土方开挖工程。 C．A．B．分包单位。 C．A．B．主要负责人。C．A．B．新工艺。 C．。。。。 of support and hanger. Cable hole plugging gaps should use qualified fireproof materials, block surface should have sufficient strength, surface appearance. When cables pass through the firewall, of lax structure of local fire safety clamps. Thermoplastics production, to comply with the process, no bubbles in the thermoplastics pipes, linear nose consistent with the core wire specifications, contact is good, no cracks, break. Tinned copper nose clean solder full exterior surface is smooth without burrs. Control cable Assembly should be fastened, dense, solid, clean, and beautiful. Secondary wiring the cable terminations should be arranged by the actual location of the device line cards, the wiring from the upper to the lower, from left to right in the order. Fixed to maintain consistent spacing between lines, flat, should be around the corner in the same location, same shape, to ensure that the wiring process neater and more elegant. 5 thermal process control measures for quality problems 5.1 control thermal duct system leakage measure to ensure that the use of electric door and actuator installation quality and equipment to the site to check its seal, acceptance, in order to fundamentally solve oil spill problems. Plant for local Panel after installation, in conjunction with the quality Department to check its overall quality, poor-quality parts replacement. Supply good quality of purchasing instrument and ovality of the guarantee instrument tubes as small as possible, selection of high quality, high precision sleeve connector. Instrument pipe weldi