半自动高精密锡膏刷机说明书.doc

锡膏印刷机 Stencil Printing Machine 使用说明书 Instruction Manual 电气控制面板K-01 Electrical Control Panel K-01 1 2 3 5 4 准备按钮1 Preparation button 1 电源按钮 Power button 印刷速度电位器 Printing speed potentiometer 触摸屏 Touch panel 准备按钮2 Preparation button 2 叁:本机操作及控制要领 III. Instruction about Operation and Control of This Device 机台原点确认 I. Confirmation of equipment origin 开机后原点自我确认,成立条件 S1,S3 或 S1,S4 The origin is self confirmed after powering on, with the tenable condition of S1, S3 or S1, S4 . 归零设定要领 II. Instruction about Zeroing 首先钢网模板夹臂8个五星把手螺丝压紧钢网模板,将机体下降至S2下始点.把PCB放于台板上转动印刷机顶部之升降手轮,依PCB厚度调节钢网模板与印刷台板之间距离. 上钢网模板前确认机体下降至S2与印刷台板之间距离＞PCB高度，否则会出钢网模板或机台受损；测量方法：目测 First, tightly compress the 8 five-pointed star knobs on the clip arm of the steel mesh molding board with the steel mesh molding board, lower the machine body to the lower initial point S2. Place PCB on the bedplate, rotate the top of the printing machine to lift the hand wheel to adjust the distance between the steel mesh molding board and the printing bedplate in accordance with the PCB thickness. confirm that the machine body goes down to S2 and the distance with the printing bedplate ＞ PCB height, or the steel mesh molding plate or the bedplate will be damaged; the measurement method: visual 支撑PIN设定方式： III. Supporting PIN Setting Mode 本机之定位PIN可移动请依钢网模板之图形概略将支撑PIN放于台板适中位置； The positioning PIN of this device is movable, please place the supporting PIN in a proper position on the bedplate in accordance with the sketch diagram of the steel mesh molding plate. 对网设定方式 IV. Mesh Calibration Setting Mode 完成上述动作后,再进行印刷钢网模板与印刷PCB校对方法如下:将PCB放于支撑PIN上,并用定位PIN定位牢固, 至少定位PCB三点 ,放于钢网模板与PCB对准焊盘,之后移动钢网夹臂将钢网夹牢,再到PCB台板之X、Y调节螺栓进行调校微调.对好位置后再把台板下的锁紧螺丝拧紧.方可进行批量印刷。 When the above actions are done, calibrate the printing steel mesh molding plate and the printing PCB, and the method is as follows: place PCB on the supporting PIN and position and fasten it with the positioning PIN. At least three points of PCB shall be positioned , place th