proe如何建定向视图.doc

利用proe中的重定向功能进行工程图剖视图的创建 以下为举例： 1.随便做个拉伸件。 工程图中打算以DTM1做剖视图。 建立该三维模型的工程图，在工程图中插入一般视图后，选取定向方法中在模型视图名中没有DTM1的方向，或在几何参照中，无法选中DTM1作为前视图。 这时，返回三维模型视图中，开始建立关于DTM1方向的定向视图。 首先点击启动视图管理器，进入以下界面 选择“定向”选项卡 并新建一视图名称“view0001”——enter 右击该名称，选择“重定义” 在给出的选项卡中，“前”选择DTM1，“上”选择你想使之称为上的表面，确定。我们就建立了一个新视图 然后再返回激活工程图窗口，插入一般视图后，这时在选取定向方法——查看来自模型的名称中便有了我们刚刚建立的视图名称，选择，工程图便自动摆正到你想要的方向。最后以DTM1为剖面的剖视图便建好了。 the drawings, first to become familiar with the drawings, mainly about the following aspects: 1) pages of drawings and diagrams, maps; 2) a comprehensive understanding of drawing; 3) finding of design-driven dimensions (), do not resize and adjust the size; 4) questioned the drawings; 5) develop buries a construction programme and technical clarification; 6) clear corners and special treatment; 7) controlled construction drawings to verify construction scheme and design. (2) at the construction site to find subject planted area: various engineering, first on the scene to find planted area, it must first understand the curtain wall installation section, and some projects are all curtain wall, the entire project is a region-wide, only partial walls, the zone is local. (3) identify the axis positioning: positioning the drawings shown in axis compared with the actual construction site to find out exactly where the axis positioning, axis positioning function are: 1) to help determine the origin of curtain walls; 2) acceptance of the installation is accurate; 3) adjust errors, and determine the error range. (4) find anchor points: according to site to find the exact location of the axis, according to the drawings provided by the content determine the positioning point; number of anchor points shall not be less than two points. Repeated measurements determine the location points must ensure that the positioning is correct. (5) take level (level): level (minor works available in horizontal pipe), the two anchor points determine the horizontal position. Level according to use