ERP-创建工路线的操作手册.doc

一、工艺路线的创建： 方法1： 路径：SAP菜单→后勤→生产→主数据→工艺路线→工艺路线→标准工艺路线→CA01—创建 详细步骤： 步骤1：选择CA01，进入屏幕1——初始屏幕 屏幕1 输入后回车进入步骤2 步骤2：填写表头细节，在屏幕2当中按提示操作，选择“用途”、“状态”、“计划工作中心”等，在导航栏上选择“工序”按进入步骤3 屏幕2 步骤3：工序分配选择各工序的工作中心以及控制码等。 屏幕3 完成后在导航栏选择“组件分配“进入步骤四 步骤四：组件分配： 屏幕4 在物料构成总览当中选中要分配的项目，然后选择“重新分配”，出现屏幕5 ，输入工序以及顺序，回车修改成功。 屏幕5 方法2：在导航栏输入事物代码CA01 步骤：无 事物代码：CA01 二、工艺路线的更改 方法一： 路径：SAP菜单→后勤→生产→主数据→工艺路线→工艺路线→标准工艺路线→CA02—更改 步骤： 1，选择CA02，双击进入屏幕6 屏幕6 输入后回车进入屏幕7 2，更改或添加工序，组件重新分配 屏幕7 方法2：在导航栏输入事物代码CA02 步骤：无 事物代码：CA02 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil