IBM ThikPad T60 X60 升级BIOS的方法.doc

IBM ThinkPad T60 X60 升级BIOS的方法-图文教程 记事本_IT故事 2008-06-21 20:37:50 阅读863 评论0 字号：大中小 IBM ThinkPad T60 X60 升级BIOS的方法-图文教程！ ThinkPad进入60时代，BIOS是升级变得简单易行，在windows下即可完成，和安装一个普通软件一样的简单。 但是升级bios出现问题，还是会有比较严重的损失，所以，升级前请注意： 1：电池有较多电量（官方建议充满） 2：插好适配器 3：系统是稳定的状态，保证升级的1~2分钟内不死机，并关闭所有的应用软件 4：机器上不要接任何外接设备，包括USB设备 BIOS升级过程如下： 运行从网上下载的BISO升级程序： 点NEXT，下一步： 接受条款： 和ThinkPad所有的驱动程序一样，下载的这个EXE文件只是一个自解压缩文件，现在执行的只是一个释放的过程，要记住释放的路径，好到相关的文件夹运行安装程序。 默认的解压路径是C:/DRIVES/FLASH/79uj16us 解压缩的过程就完成了。 下面是安装过程： 先到刚才释放的默认文件夹（C:/DRIVES/FLASH/79uj16us），找到WINUPTP，就是红箭头指向的文件，双击运行 选择升级BIOS 安全提示：升级前，要保证机器是插适配器，有电池，并关闭所有的应用程序 问是否继续，点YES 程序会自动进行BIOS升级，不要进行干扰 看到下面的信息，恭喜，升级成功啦:lol ，从新启动一次ThinkPad，升级即告完成。 BIOS下载：/pc/support/site.wss/TPAD-MATRIX.html stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed e