POLO音响改 青岛道声(煜丰隆)汽车音响改装案例解析.doc

POLO外观时尚前卫，小巧而不失风雅，是一部不可多得的家庭用车首选，本次车主初次改装，选择了经济实惠性价比较高的套装喇叭，作为升级产品，升级之后整体听感圆润丰满，最大限度地还原出真实的声音。 侧身来张靓照 本次改装所需要的配置 拆开后的车门内饰 拆开后的车门空荡荡的，没有任何隔音止震的作用。 车门做的标准的双层加强型隔音，先在门板内侧贴上条形止震板 细节部分来个特写 然后再在门板外面贴上整张止震板，车门双层加强型隔音，使车门形成一个密闭的箱体，不仅能有效的抑制车门钢板振动产生的噪音，同时为喇叭的发挥提供良好的发挥空间。 中控部分 安装喇叭 安装好的喇叭来个特写 改装完成，提交作业！ stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor not and stator core coil collide friction. Slow journey to move into the direction of the