WebSphee修改主机名方法.doc

WebSphere6修改主机名方法 备份配置文件 WebSphere配置文件 在作出改变之前，先使用 WebSphere Application Server 备份工具 backupConfig.(sh/bat) 对配置进行备份backupConfig.sh，如下图所示 操作系统配置文件 备份操作系统主机名相关配置文件/etc/hosts和/etc/sysconfig/network 修改配置文件 检查初始配置 查看WebSphere初始配置，包括管理节点、受管节点和各节点对应的主机名，如下图所示，分别为管理的节点和节点对应的主机名，并确保节点为启动状态和记录相应节点的名称，修改配置文件中主机名时需要使用。 修改WebSphere配置文件中主机名信息 启动wsadmin 输入以下命令： 列示服务器配置文件的内容AdminConfig.save()命令保存配置修改，如下图所示： 检查修改后配置 使用AdminConfig.show命令检查配置文件中主机名是否修改，如下图所示 检查管理控制台相应节点主机名 退出重新登陆部署管理器后，可以看到修改被反映到管理控制台中。 检查配置文件serverindex.xml主机名是否修改 修改主机名 修改配置文件/etc/hosts 修改配置文件/etc/sysconfig/network 重启网络服务 验证 停止管理控制台和节点 重启机器验证机器名 启动管理控制台和节点 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two p