WIN-xp系AHCI驱动的安装方法.doc

windows XP系统下如何开启AHCI硬盘工作模式（XP系统下如何加载AHCI驱动） 问题描述使用IDE模式安装XP系统后开启AHCI模式会出现开机蓝屏重启的问题，咨询如何在XP下加载AHCI驱动，以便开启BIOS中AHCI选项来发挥硬盘的最佳性能。问题分析 xp系统无法直接支持AHCI硬盘高速模式，需要加载AHCI补丁后才可打开BIOS中的硬盘模式。 解决方案 1、未加载AHCI驱动（已安装芯片组驱动）时设备管理器截图2、下载SATA驱动并解压缩 3、重新启动，修改BIOS下SATA工作模式为AHCI选项，以下修改硬盘模式方法为“AHCI”，有些则为Enabled或Disabled（不同机型BIOS中硬盘模式修改位置及方法略有差别）4、进入系统启动完成时系统提示发现新硬件向导指向路径：解压后的SATA驱动根目录安装成功：单击完成即可5、下图为安装完成界面 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor