主板刷BIOS解教程.doc

刷BIOSBIOS的方法： 注意：AMD主板更新BIOS前，如有开核或超频，请先导入CMOS出厂默认值后在进行更新BIOS动作，否则可能刷新后不开机！ 1.主板自带更新方式(推荐使用） 2. AFUDOS 工具更新BIOS(DOS下更新刷BIOS) : 1. 主板自带更新方式 1-1.?F12进入BIOS POST Flash 1-2. 选择设备Select drive,依配备选择?Update BIOS装置来源,例如：USB ZIP或Floppy..等 1-3.?选择要更新?的BIOS,并注意?Model Name及Chipset是否正确 1-4.?询问是否确定要?更新 : Are you sure to flash BIOS (Y/N)???Y (按Y) -5.?询问是否清除?DMI资料：??Erase DMI Date (Y/N) ???Y (按Y) 1-6.?BIOS 1-7. 升级BIOS完成,询问是否要重开机：BIOS Flash done,Reset system (Y/N)??Y(按Y) ,即完成BIOS的升级。 2. DOS下升级BIOS 2-1.?执行afudos来update bios,?输入afudos?空一格?+ BIOS完整檔名,按Enter?后执行 2-2. 擦除原来的flash 2-3. 写入新的flash 2-4. 验证flash 2-5. Program ended normally完成BIOS更新,并顺利开到?A:\下,升级过程中无死机或错误讯息,即完成BIOS更新 注意！以上方法只用于AMI BIOS系列主板 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear