修复安装WinowsXP的步骤.doc

修复安装WindowsXP的步骤 步骤１、启动计算机，看到蓝色DELL标志画面时，屏幕的右上角会出现提示：F2=Setup，?F12=Boot?Menu。此时需要迅速按下键盘上的F12键。注意：最多按两下F12键就足够了，否则键盘可能会被锁住，到了第５步时键盘将无法使用。 ２、然后就会出现如下图所示的启动设备选择菜单老机器如左，新机器如右：菜单的排列顺序以及可选择的项目因机型与机器配置的不同会略有区别 ３、放入操作系统安装光盘，用键盘的↑或↓箭头按键将光标移动到带有CD-ROM字样的选项（老机器如左图第4项，新机器如右图第3项），按Enter键回车。在从安装光盘引导之后，当屏幕上出现如下图所示的提示时，需要在5秒之内再按一下Enter键回车。如果此时不按ENTER键回车，则会从硬盘启动 ４、然后会进入蓝色的Windows安装程序界面（此时屏幕的左上角有Windows?Setup的字样）。 ５、安装程序载入一些设备驱动后，会有短暂的黑屏，稍后出现如下画面，按Enter键回车，开始安装。注意：想要尝试进行系统修复安装的，这边也是按Enter键回车，而不是按R键。 ６、按回车键之后，将会出现Windows?XP许可协议，按F8键按受协议。 ７、随后，安装程序会询问检测到一个受损的操作系统，询问是否修复，按『R』键开始修复即可。 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end