利用红雪自制固平刷系统.doc

利用红雪自制固件平刷系统 首先，准备好官方固件 然后， 工具齐了，打开红雪。（记住一定要用英文原版的红雪）  进入红雪选第2个 选第4个“SHSH blobs”： 选第1个“Fetch”： 进入这个界面之后点“Next”同时准备将iPhone进入DFU模式； 进入DFU模式操作： 按住电源开关键3秒 保持按住电源键不要松开，同时按住home键10秒 松开电源键，保持按住home 键15秒键不要松开按住电源开关键3秒 保持按住电源键不要松开，同时按住home键10秒 松开电源键，保持按住home 键15秒键不要松开进入DFU模式之后剩下的事情他就会自己完成了。直到屏幕出现激活样式。打开itunes。自己激活。选择成新的iphone..  stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor not and stator core coil collide friction. Slow journey to move into