怎样在工程图中入展开图.doc

！ North Gate Station and all the long distance Intercity, TRANS-province lines; North Gate Station currently runs the original counties, rural routes; Simon, station main, Yibin city, across the city, across the province and to the West of range line. Yibin city highway main station distribution table 3.1-6 station name grade accounted for to area m2 Gao North Gate Station and all the long distance Intercity, TRANS-province lines; North Gate Station currently runs the original counties, rural routes; Simon, station main, Yibin city, across the city, across the province and to the West of range line. Yibin city highway main station distribution table 3.1-6 station name grade accounted for to area m2 Gao North Gate Station and all the long distance Intercity, TRANS-province lines; North Gate Station currently runs the original counties, rural routes; Simon, station main, Yibin city, across the city, across the province and to the West of range line. Yibin city highway main station distribution table 3.1-6 station name grade accounted for to area m2 Gao 要想在工程图中同时有钣金展开图和工程图！ 首先：我们把产品展开 像这样，整个图形成为了平整状态 然后点击视图管理器，新建一个简化表示，随便命名自己知道就可以了 然后点击，完成/返回 然后又要从新建立以个表示，任你自己命名，然后点排除，然后点你所展平的特征，后面会出现排除的字样，确认无误，点确定——完成 就成了这样。再关闭， 好我们进入工程图 再工程图里会出现这样的情况，我刚刚的命名CP .ZK 还有一个主表示 点创建一个视图,在视图方向上选择相应的视图方向 成此情况 然后点鼠标右键，大约3秒后会出现红色对话框内的菜单，点属性 点绘图模型 点添加模型 点ZK，后按两下鼠标中建 点创建一个视图,在视图方向上选择相应的视图方向 好了 ，就这样了 ，如果哪天想不起来的话看看咯@@@@@@@@@@@@