ASTMD3359-09标准试验方法胶带法测量附着力全解.doc

Designation: D 3359 – 02 名称： D 3359-02 Standard Test Methods for Measuring Adhesion by Tape Test1 ASTM D3359-09 标准试验方法 胶带法测量附着力This standard is issued under the fixed designation D 3359; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. 这个标准是D 3359确定了以后发行的。数字代表名称最初通过的时间，或者修订情况，和必威体育精装版版本。括号内的数字代表必威体育精装版重新审批时间。上标代表必威体育精装版版本的变化或重新审批。 This standard has been approved for use by agencies of the Department of Defense. 该标准已经被国防机构部门批准使用。 1. Scope 范围 1.1 These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-sensitive tape over cuts made in the film. 本标准提出的试验方法是规定通过在漆膜切割区施加和撕离压敏胶带的方式，对漆膜与金属底材之间的附 着力进行评定的程序1.2 Test Method A is primarily intended for use at job sites while Test Method B is more suitable for use in the laboratory. Also, Test Method B is not considered suitable for films thicker than 5 mils (125μm). 试验方法A主要是供合实验室使用试验方法B被视为不适合厚度超过 5毫英寸（125微米）的漆膜NOTE 1—Subject to agreement between the purchaser and the seller,Test Method B can be used for thicker films if wider spaced cuts are employed. 注 1根据买卖双方的协议，如果切割间距较宽，漆膜较厚时可采用试验方法B1.3 These test methods are used to establish whether the adhesion of a coating to a substrate is at a generally adequate level. They do not distinguish between higher levels of adhesion for which more sophisticated methods of measurement are required. 本标准规定的试验方法用于总体判定涂层与底材之间的附着力是否达到足够的水平。如果附着力较高，本标准规定的试验方法无法精确地区分附着力的差别，需要使用更精确的测量方法NOTE 2—It should be recognized that differences in adherability of the coating surface can affect the results obtained with coatings having the same inherent adhesion. 注2-应该注意到，涂层内在附着力相同的情况下，涂覆面附着性的差别会影响测量结果1.4 In multicoat systems adhesion failure may occur between coats so that the adhesi