NAVA中文版.pptVIP

NAVA Training Presentation 2007 NAVA Training Presentation.ppt * When NAVA is installed, the Edi signal is shown as a waveform on the SERVO-i User Interface in all modes of ventilation as well as in stand-by mode, i.e. in the positioning window. As numerical values, the Edi peak and Edi min are available. Edi peak – the highest value during one breath cycle. Edi min – the lowest Edi value during one breath cycle. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * Insert Edi Module into the SERVO-i and connect the Edi Cable. Test the Edi Module and the Edi Cable with the test plug. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * NAVA Training Presentation 2007 NAVA Training Presentation.ppt * Measure the distance from the bridge of the nose (N) via the Earlobe (E) to the Xiphoid Process (X). Note down the NEX measurement in centimeters. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * For nasal insertion multiply the NEX value by 0.9 and add the extra centimeters as shown in the table. Note down the calculated value for the Edi Catheter insertion length Y in centimeters. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * For oral insertion multiply the NEX value by 0.8 and add the extra centimeters as shown in the table. Note down the calculated value for the Edi Catheter insertion length Y in centimeters. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * Dip the Edi Catheter in water to activate its lubricant prior to insertion. Avoid wetting the connectors. NoteDo not apply any other substance than water to the Edi Catheter. Lubricants, gels or solvents may destroy the coating and the contact with the electrodes. Insert the Edi Catheter and advance it down the esophagus to the calculated Y length. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * Connect the Edi Catheter to the Edi Cable. NAVA Training Presentation 2007 NAVA Training Presentation.ppt * Open the