识别油气井径向流选层.doc

识别油气井径向流选层 提高老井重复压裂措施效果对油田的可持续发展变得尤为重要。基础井网压裂井数比例达86.76%，压裂厚度达74.5%； 压裂投产后油气井的生产特征一般分为3个阶段。 Improve the effect of old well repeated fracturing measures for the sustainable development of the oilfield is particularly important. Basic well pattern fracturing well number proportion reaches 86.76%, the thickness of the fracturing was 74.5%; Fracturing of oil and gas well production characteristics after the production of general is divided into three stages. 　　（1）线型流阶段。此阶段原油从支撑裂缝前缘流向井筒，为压后高产阶段，不过产量下降较快。 (1) linear flow phase. At this stage of crude oil is flowing from support crack front shaft, for high yield after pressure stage, but the decline in output quickly. 　　（2）拟径向流阶段。此阶段原油一方面从支撑裂缝前缘流向井筒，另一方面也从裂缝两侧基岩流入井筒。此时产量已低于第一阶段产量，但生产能力仍高于油层未经过压裂改造前的产量，此阶段产量较稳定。 (2) the phase of quasi radial flow. This stage of crude oil is flowing from support crack front shaft on one hand, on the other hand also on both sides of the bedrock from the cracks into the wellbore. Production at this point is below the first stage of production, but production capacity is still higher than before after fracturing oil layer of the production, the output of this stage is relatively stable. 　　（3）径向流阶段。此阶段支撑裂缝已失去了高导流能力，生产能力已恢复到压前水平。压裂井经过线型流、拟径向流直至径向流，增产期即告结束，此时，原油处于经济生产下限，应考虑重复压裂。 (3) the radial flow stage. This stage to support cracks has lost high flow conductivity, production capacity has been restored to the front of the pressure level. Fracturing Wells after linear flow, quasi radial flow and radial flow, production period is come to an end, at this point, the crude oil in the economic limit production, repeated fracturing should be considered. 支撑剂镶嵌到裂缝壁面，减小了裂缝宽度，使导流能力下降，其影响达到20%以上；同时对裂缝壁面产生压实作用，加大了地层流体进入裂缝的渗流阻力；　以往原缝重复层压裂措施有效率为40%左右，有效井压后初期平均单井日增油仅为平均压裂井增油效果的1/3，平均有效期只有3个月。 Proppant inlaid into the cracks in the wall, decrease the crack width, the diversion ability drops, its influence to over 20%; Compaction on the cracks in the wall at the same time, increased the forma