key如何使用遥控器..doc

How to use the remote: 1. Plug the receiver unit into any USB port. 2. Your operation system will start to setup the receiver unit automatically. And you can see the information as below display in you computer. 3. But in Win98/Me operation system you need to follow the dialog boxes on your screen. During the install process, the O/S may ask you to put Win98 CD into the CD-ROM.  Notice: 1. If the remote is not working or interference with another: 1-1 Press the M-key and Composite Switch together at least 5 seconds (The M-key green LED will flash) (To change a new ID). 1-2. Use a paper clip to press the red button (Stand by to learn the new ID). 1-3. Push any button except laser key and M-Key (Let receiver learn the new ID). 2. If you remove the battery or the remote does not work, repeat the steps 1-1 to 1-3. 3. Any key will be not on any more after it is kept working 40 seconds. 4. When the receiver red button is pressed more than 5 seconds, the receiver will not receive any code. Then you have to do the steps 1-1 to 1-3 to start the remote. Ai-Remote Functions introduction  Mode-1 Mode-2 (Multimedia) 1.Laser Pointer Button Laser Pointer ON/Off Windows Media Player On 2.Full Function Mouse Control Mouse cursor Up: The Last Song Down: The Next Song 3.Left Mouse Key Left Mouse Key Play/Pause 4.Right Mouse Key Right Mouse Key Stop 5.M-Key Green LED Off Green LED On 6.Composite Switch Up: Line Up Down: Line Down Push: Drag Up: Volume Up Down: Volume Down Push: Mute Notice: 1) Press M-Key to change mode. When you change into mode 2, the M-Key green LED will on 5~10 seconds, then flash 1 time per 3 seconds about 10 minutes. 2) In Mode-1, M-Key with 2 special function. Function 1: M-Key+ Laser Pointer Button Press M-Key and Laser pointer button together more than 3 seconds (The M-key Red LED will flash) to enable/disable the laser pointer button. Function 2: M-Key+ Composite switch Push Key (ID Change)