注塑模具DFM报告模板-1.pptVIP

Hier beginnt das Professionelle Service Parts Analysis Report “Engineering global parts” Project No.:10CE697.3 Part Name.: housing 产品名 项目号 cavity core ACTUATOR HAND PL Banana gate will be in here Basic Mold Information Cavity Slider/Lifter Resin Shrink Steel Gate Type Mold Type 出数 斜顶行位数 胶料 缩水率 钢料 入水形式 模具类型 1X2 NONE ABS 1.005 H13 Cold runner with sub gate 2 plate mold shrinkage rate correct? Kindly advise Visible area _确认外观面 Is this part a visible one? If so kindly advise the where the visible area . 表达运水 表达流道 表达放大图位置 G G Section G-G 基本直线 基本箭头 (1.0mm) (1.0mm) 表达各种尺寸 表达截面 一些有用的图形 基本文本框 A A please advise 表达运水 表达流道 基本直线 基本文本框 please advise 鼠标在直线上点击右键，再点击设置为默认线条， 设置好后就可以画出与这条线一样的线条啦！ PS：设置好默认线条后，默认箭头会自动设置好！ 同理，文本框与运水，流道也可以右键设置默认来方便画? Layout _模具排位 表达运水 表达流道 Slide 行位 斜顶 lifter Inserts split line _镶件线确认 Insert here, OK? 这里做镶件,OK? Insert split line in red, OK? 红色镶件线,请确认 Ejection _产品顶出确认 Ejector blade Ejector sleeves Ejector pins lifter Inner slide Surface finish_产品抛光/晒纹位置确认 Is this part a visible one? If so please advise the which the visible area is and the surface finish spec. MT11010 texture for red surface, please confirm. 红色面晒MT1101纹,请确认 Other surface apply Sandpaper 600# for mold release., please confirm. 其它面省到600#砂纸出模,请确认 Draft Study _产品斜度分析 Green surfaces without draft angle now, suggest to enlarge to 1 degree at least (by reduce material) Kindly advise. 绿色面直身,建议最小减胶加1度斜度,请确认. Draft angle of the shut off surfaces (red marked) is not enough , least (by reduce material) it should be 3 degree at least. 图示红色面擦穿，斜度不足（单边最小3度） the red surface is straight, suggest add 3o draft angle on it (by reduce material) for texture MT0000, least (by reduce material), pls confirm. 红色直身面,建议减胶加3度出模角来晒纹MT0000,请确认. Wall thickness study _产品壁厚分析 Red area with uneven thickness, may cause sink marks, please help improve. 红色区域壁厚不平均,太厚了,可能缩水,请帮忙改善. Those ribs too thick, suggest thin them to 75% general part surface to avoid sink mark opposite it. Please confirm. 箭头所指骨位太厚,建议减薄到基本壁厚的75%来避免骨