双牵引维护手册英文翻译解读.doc

C AUTECH Maintenance manual Double-rail Double-head automatic puller Warning Cautions ? ? ? ? ? ? ? ? Attention Attention Attention Attention Attention Attention Attention Attention Think twice before operation Wearing eye protection equipment Observing the content in the machine operation Disconnect and lock the power supply before maintenance Read the instructions carefully before operation Ensure the protective facilities installed in place Ensure the cutting tools installed firmly Pay attention to other matters within the region before starting the machine Prohibited items ??Prohibited ? ? ? ? ? Prohibited Prohibited Prohibited Prohibited Prohibited Putting hand or other body parts into machine or cutting region before disconnect and lock the power Operating before the protective facilities installed in place Opening the protection door before the machine is fully stopped Operating the machine without training Away from the operator position when machine is running Wearing loose clothes, gloves or jewelry CWarningN AUTECH maintenance bulletin Cleaning procedures for double-head puller’s conductive rail The low voltage part of the conductive rail must be cleaned every once in a while, it’s length of time interval varies according to factory condition. When collecting boots wear and conductive rail have dirt, the communication system of extrusion puller is prone to errors. Communication failures for some of the phenomenon: (1) false extrusion puller failures; (2) Multiplexing com fault; (3) wrong or needless move of the extrusion puller. You can operate in accordance with the following procedure if you have doubt about the communication failure of conductive rail ： . Pull the disconnect handle on the main control board, disconnect all power. Break the lock according to the operation manual of “equipment lock”. Inspecting the electric boots of per extrusion puller, check up its side and sliding surface uneven wear. Repairing collector b