MarkⅥ报警清单讲解.docx

Mark Ⅵ报警清单燃机及发电机报警编号报警等级报警逻辑名英文报警信息及中文说明2BTJ1_1_ALMBRG METAL TEMP TURB JOURNAL #1 HIGH燃机#1 轴承金属瓦温高2BTJ1_2_ALMBRG METAL TEMP TURB JOURNAL #1 HIGH燃机#1 轴承金属瓦温高2BTJ2_1_ALMBRG METAL TEMP TURB JOURNAL #2 HIGH燃机#2 轴承金属瓦温高2BTJ2_2_ALMBRG METAL TEMP TURB JOURNAL #2 HIGH燃机#2 轴承金属瓦温高2L12H_ACC_ALMPROT MODULE SPEED SGNL LOSS (DECEL DET)保护模块转速信号丢失1L12H_ALMELECTRICAL OVERSPEED TRIP – HP电超速遮断—HP2L12H_FLT_ALMLOSS OF PROTECTIVE HP SPEED SIGNALS电超速遮断—LP2L12H_P_ALMPROTECTIVE OVERSPEED STATUS保护模块超速遮断1L12HBLT_ALMPROTECTIVE OVERSPEED BOLT TRIP超速螺栓保护跳机2L12HF_ALMCONTROL SPEED SIGNAL LOSS – HP控制转速信号丢失—HP2L12HFD_C_ALMCONTROL SPEED SIGNAL TROUBLE控制转速信号故障—HP2L12HFD_P_ALMPROTECTIVE SPEED SIGNAL TROUBLE保护转速信号故障2L25A_ENAB_ALMI-2ZK5A RELAY HAS NOT BEEN ENABLEDK25A继电器尚未得电2L26BT2H_ALMTURBINE COMPARTMENT TEMPERATURE HIGH透平间温度开关高温报警2L26EX_ALMEX2K POWER CONV MODULE TEMP HIGHEX2000 功率转换器模块温度高1L26EX_T_ALMEX2K PWR CONVERSION MOD TEMP HIGH-TRIPEX2000 功率转换器模块温度高跳机2L26FTGPL_ALMFUEL TEMP HIGH FOR DIFFUSION GOV LOWER对于扩散燃烧，燃料气温度高应降低一点2L27F1_ALMFIRE PROTECTION TRIP RELAY UNDERVOLTAGE防火保护跳机继电器低电压2L28FD_ALMFLAME DETECTOR TROUBLE火焰监测器故障1L28FDT_ALMLOSS OF FLAME TRIP熄火跳机2L30BN_F_ALMBENTLY NEVADA MONITOR FAULT火焰信号失去遮断2L30BTA_ALMBEARING METAL TEMPERATURE HIGH轴承金属温度高2L30CC1_ALMFIRE PROTECTION SYSTEM TROUBLE火灾保护系统故障3L30COM_EXFLTEXICTER TO MkVI COMMUNICATION FAULT励磁机与MkVI 的通信故障1L30COM_SSFLTEGD LINK TO THE LCI FAULT到LCI 的以太网全局数据库EGD 链故障3L30COMM_IO_RVCMI IO STATE EXCHANGE FOR R FAILED VCMII/O状态转换〈R〉失败（仅MKⅥ）3L30COMM_IO_SVCMI IO STATE EXCHANGE FOR S FAILEDVCMI I/O 状态转换〈S〉失败（仅MKⅥ）3L30COMM_IO_TVCMI IO STATE EXCHANGE FOR T FAILEDVCMI I/O 状态转换〈T〉失败（仅MKⅥ）1L30CSURGCOMPRESSOR STALL DETECTED探测到压气机失速2L30DPFLT_ALMDEW POINT TEMPERATURE SENSOR FAULT露点温度传感器故障1L30EX_TRIP_AEX2K TRIPEX2000 跳机2L30FD_ALMFAILURE TO IGNITE点火失败2L30FGWI_ALMFUEL GAS SYS LOWER DUE TO WOBBE INDEX燃料气系统韦伯指数低2L30FORCED_ALSIGNAL FORCING ENABLED强制信号“使能”2L30FPG2L_ALMGAS FUEL INTER-VALVE PRESS. (P2) LOW气体燃料进气阀压力(P2)低2L30FTGH_ALMFUEL GAS TEMPERATURE HIGH气体燃料温度高1L30FTGHH_ALMFU