贴片电解电容.docVIP

贴 片 铝 电 解 电 容 1.范围Scope 适用“RVT系列”立式片式铝电解电容器 This specification covers “RVT Series” V-chip aluminum electrolytic capacitors. 2.参考标准Reference Standard 日本工业标准JIS C-5141、JIS C-5102 Japanese industrial Standard JIS C-5141 characteristics W and JIS C-5102 except as specified in this specification. 3.环境保护标准Environmental Protection Standard 遵照欧盟指令2002/95/EC. Comply with the EU directive 2002/95/EC. 4.使用温度范围Operating Temperature Range -55(C ~ +105(C 5.电压范围Voltage Range 6.3 ~ 100V 6.容量范围Capacitance Range 4.7~ 1500(F 7.容量偏差范围Capacitance Tolerance (20% at 120Hz, 20(C 8.漏电流Leakage Current 2分钟后读数 I ≤ 0.01 CV or 3 ((A) whichever is greater (after 2 minutes) 9.损耗角正切Tan ( 测试频率：120Hz，温度：20℃ Measurement frequency: 120Hz, Temperature: 20(C Rated Voltage (V) 6.3 10 16 25 35 50 63 100 Tan ( (max.) 0.30 0.24 0.20 0.18 0.16 0.14 0.12 0.12 10.低温特性Stability at Low Temperature 测试频率：120Hz Measurement frequency: 120Hz Rated Voltage (V) 6.3 10 16 25 35 50 63 100 Impedance Ratio ZT/Z20 (max.) Z-25(C /Z+20(C 4 3 2 2 2 2 2 3 Z-40(C /Z+20(C 10 8 6 4 3 3 3 4 11．耐久性Load Life 105℃施加额定电压1000小时后，电容器应满足以下要求 After 1000 hours application of rated voltage at 105(C, capacitors meet the characteristics requirements listed. 容量变化率 Capacitance Change ±30%初始值内 Within (30% of initial value 损耗角正切值 Tan ( ≤300%初始规定值 300% or less of initial specified value 漏电流 Leakage Current ≤初始规定值 Initial specified value or less 12.高温储存Shelf Life 105℃放置1000小时后，满足以下要求 After storage for 1000H at 105℃±5℃ 容量变化率 Capacitance Change ±30%初始值内 Within (30% of initial value 损耗角正切值 Tan ( ≤200%初始规定值 200% or less of initial specified value 漏电流 Leakage Current ≤300%初始规定值 300% of less of Initial specified value. 13.耐焊接热Resistance to Soldering Heat 经过回流焊后在温室中恢复后，电容器满足以下要求 After reflow soldering according to Reflow Soldering Condition (see pag8e 5) and restored at room temperature, they meet the cha