钻进英语.docVIP

目录 钻井作业英语2 井下作业英语13 泥浆现场实用英语21 PART 1. 准备工作 (Getting Ready)21 PART 2. 泥浆设计 (Mud Design)22 PART 3. 配浆和处理 (Mixing And Treatment)24 PART 4. 钻井工程A (Drilling Engineering A)25 PART 5. 钻井工程B (Drilling Engineering B)26 PART 6. 固相控制 (Solids Control)27 PART 7. 井下复杂情况A (Complex Circumstance A)28 PART 8. 井下复杂情况B (Complex Circumstance B)29 PART 9. 泥浆房试验 (Testing In Mud Room)30 PART 10. 完井作业 (Completion)31 PART 11. 作业安全 (Safety)31 PART 12. 泥浆处理剂 (Mud Materials)32 PART 13. 泥浆报表 (Mud Report)33 PART 14. 公司介绍 (Service Introduction)34 测试作业英语35 石油工程作业英语50 现场常用英语60  钻井作业英语 1. The rigging up is finished. 钻机已安装完毕。 2. Let’s start to check and test the rig. 现在开始检查和调试钻机。 3. The rig isn’t checked and tested. 钻机还没有检查调试呢。 4. All the operation should be done per normal procedures. 所有操作都应该按正规程序进行。 5. It is not allowed to work on the rig floor without helmet on. 不戴安全帽不许上钻台工作。 6. The safety belt should be fastened when working on the derrick. 上井架工作必须系好安全带。 7. Has your safety belt been fastened? 你系好安全带了吗？ 8. Wine drinking is not allowed before going to work. 上班前不许喝酒。 9. Spud in will begin at about one o’clock in the afternoon. 大约下午1:00可以开钻. 10. For the first spud in, penetration rate is 160 and weight on the bit is two thousand pounds. 一开钻采用钻数160rpm钻压2千磅。 11. What is the penetration rate? 钻速多大？ 12. The weight on the bit is less than two thousand pounds. 钻速不到二千磅。 13. Use both pumps with 100 strokes per minute and pressure of 6 MPa. 开双泵，泵冲100，泵压6兆帕。 14. Shall we use both pumps? 开双泵吗？ 15. Do a dummy trip after single joint until the first spud in finished. 打完单根眼一次，直到打完一开。 16. Circulate for one and half hours before pulling out.  循环一个半小时再起钻。 17. How long to circulate before pulling out? 循环多长时间再起钻？ 18. Report at once if any unusual case occurred. 如有特殊情况，要马上报告。 19. Control the running speed when going in the hole. 下钻要控制下放速度。 20. Be careful not to make fr