LEDandButtonDescriptionsTroubleshootingTips.pdfVIP

LED and Button Descriptions Power LED Powerline LED Ethernet LED Factory Reset Security button Ethernet port Item Power LED Powerline LED Description ? Solid green. The electrical power is on. ? Solid amber. The adapter is in power saving mode. ? Blinking green. The adapter is in the process of setting up security. ? Off. There is no electrical power. ? Solid. The adapter is connected to a Powerline network. ? Off. The adapter has not found any other compatible Powerline devices using the same encryption key. The Pick A Plug feature lets you pick the electrical outlet with the strongest link rate, indicated by the color displayed by the LED: Green: Link rate 80 Mbps (Best) Amber: Link rate 50 and 80 Mbps (Better) Red: Link rate 50 Mbps(Good) Item Ethernet LED Description ? Solid. The Ethernet port is linked. ? Off. There is no Ethernet connection. Security button Factory Reset After you plug in your new AV adapter, press the Security button for 2 seconds, then press the security button on one of the other AV adapters in your existing network for 2 seconds. Both buttons must be pressed within 2 minutes. Note: The Security button does not work in power saving mode (see “Power LED is amber” in the Troubleshooting Tips table). Press the Reset button for 1 second, then release it to return the Powerline adapter to its factory default settings. Warning: Do not press the Security button on the Powerline adapter until installation is complete and the adapters are communicating with each other (indicated by the blinking Powerline LED). Pressing this button too soon can temporarily disable Powerline communication. If this should occur, use the Factory Reset button to return the Powerline adapter to its factory default settings. Troubleshooting Tips Power LED is off Make sure that power is supplied to the electrical outlet, and that the Powerline devices are not plugged into an extension cord, power strip, or surge protector. Power LED is amber Power saving mode occurs whe