Callmanager express 文档总结.docVIP

Callmanager express 文档总结 Callmanager express 文档总结 转自 作者：Trofish Software Prerequisites： ? Cisco IOS Software ? Cisco CallManager Express Files IOS的要求： Cisco CME 3.3 requires a minimum of an 12.3(14)T IP VOICE image on the Cisco 2600XM, 2800, 3600, 3700, and 3800 series, and an IP/ADSL VOX PLUS image on the Cisco 1751-V and Cisco 1760 series. If you are using AIM-ATM-VOICE-30 on Cisco 2600XM, 3600, and 3700 series, a minimum of SP SERVICES image is required. Callmanager文件要求： Download *.zip，解压后，上传到flash.除了：For phone firmware files, copy only the firmware files for phone types that you have at your site. For CiscoIOSTSP.zip, refer to the installation instructions in the “Cisco IOS TSP Download and Setup” section in the “Configuring Productivity Tools” chapter. 上述两种不要. 或者.tar的文件. phone firmware files的对应表 参见这里: /univercd/cc ... /cme33/cme33spc.htm 7970G and 7971G-GE电话使用多个文件,见文档38页. 38页上的7940,7960例子: Step 1 Download P00305000301.zip /cgi-bin/tablebuild.pl/ip-iostsp to obtain the files required to covert unsigned loads to signed loads. Step 2 Copy a 5.0 phone load that has a .bin extension on to the router flash. Router # copy tftp://x.x.x.x/P00305000300.bin flash: Router (config)# tftp-server flash00305000300.bin Router (config)# telephony-service Router (config-telephony)# load 7960-7940 P00305000300 Step 3 Reset the phone so that it picks up the 5.0 bin file. Router (config)# telephony-service Router (config-telephony)# reset all Step 4 Check the firmware version running on the phone and ensure that the phone did pick up the 5.0 load. Router (config)# show ephone phone-load Step 5 Disable the TFTP sharing of P00305000300.bin after all phones have upgraded to the interim image. Router (config)# no tftp-server flash00305000300.bin Note You may delete this file from flash as it is not required any more. Step 6 Copy a 5.0 secure phone load that has a .sbn extension onto the router flash. Router # copy tftp://x.x.x.x/P00305000301.sbn flash: Router (config)# te