AS00SCM-A.pdfVIP

AS00SCM-A EN Instruction Sheet TR Bilgi D?kümani TW 安裝說明 CN 安装说明 EN ? This is an OPEN TYPE module and therefore should be installed in an enclosure free of airborne dust, humidity, electric shock and vibration. The enclosure should prevent non-maintenance staff from operating the device (e.g. key or specific tools are required for operating the enclosure) in case danger and damage on the device may occur. FR ? Ceci est un module ouvert et il doit donc être installé dans un coffret à l’abri des poussières, des vibrations et ne pas être exposé aux chocs électriques. Le boitier ou l’armoire doit éviter toute action d’un personnel autre que celui affecté à la maintenance de l’appareil (par exemple, clefs, outils spécifiques pour l’ouverture du coffret), ceci afin d’éviter tout accident corporel ou endommagement du produit). TR ? Bu ürün A?IK T?P bir modül olup toz, rutubet, elektrik ?oku ve titre?imden uzak kapal? yerlerde muhafaza edilmelidir. Yanl?? kullan?m sonucu ürünün zarar g?rmesini ?nlemek i?in yetkili olmayan ki?iler taraf?ndan ürüne müdahale edilmesini ?nleyecek koruyucu ?nlemler al?nmal?d?r. (ürünün bulundu?u panoya kilit konulmas? gibi). TW ? 本機為開放型（OPEN TYPE）機種，因此使用者使用本機時，必須將之安裝於具防塵、防潮及免於電擊?衝 擊意外之外殼配線箱內。另必須具備保護措施（如：特殊之工具或鑰匙才可打開）防止非維護人員操作或意 外衝擊本體，造成危險及損壞。 CN ? 本机为开放型（OPEN TYPE）机种，因此使用者使用本机时，必须将其安装于具防尘、防潮及免于电击/冲 击意外的外壳配线箱内。另必须具备保护措施（如：特殊的工具或钥匙才可打开）防止非维护人员操作或意 外冲击本体，造成危险及损坏。 EN Please refer to the AS Series Hardware Manual for more information. TW 詳細資料請參考 AS 系列硬體手冊 TR Daha fazla bilgi i?in lütfen AS Serisi Donan?m Klavuzuna bak?n?z. CN 详细资料请参考 AS 系列硬件手册 EN Assembly TR Montaj TW 安裝 EN Clip up the two DIN rail clip on the module. Parallel the module groove on the back to the DIN rail, then push and slide along until hearing a click. TR Modül üzerindeki iki DIN ray klipsini d??a do?ru ?ekin. Alttaki modül oyu?unu DIN ray ile paralel konuma getiriniz ve sonra klik sesini duyana kadar klipsleri i?e do?ru bast?r?n. TW 將模組上下方的兩個 DIN 軌固定扣往中間壓後，將模組後方勾槽平 行對準 DIN 軌並往 DIN