[精品]EnDriveplcv20000.pdf

Drive PLC Appendix 8-4 lDrivePLC EN 2.1 8.3 System error message Overview over the error sources detected by the PLC and the possible responses. Tip! ? The current error number is also displayed in the variable DCTRL_wFaultNumber. ? The history buffer (C0168/x) stores system error messages with an offset which indicates the type of response: Type of response No. of system error message 0 ... 4 x x x 0 - TRIP 1 - Message 2 - Warning 3 - Off 4 - Error/QSP Example: The value “2061” in code C0168/1 means: “x061” The current fault (subcode 1 of C0168) is a communication error between the AIF module and PLC (see error message no. 061) “2xxx” The response is a warning. System error message Possible settings/response ? Default setting  Setting possible Available in No. Display Source Meaning TRIP Message Warning Fault/QSP Off Code Drive PLC Servo PLC 011 OC1 MCTRL Motor cable short circuit ?  012 OC2 MCTRL Motor cable earth fault ?  015 OC5 MCTRL I x t overload ?  020 OU MCTRL Overvoltage in DC bus ?  030 LU MCTRL Undervoltage in DC bus ?  050 OH MCTRL Heat sink temperature higher than fixed limit temperature ?  053 OH3 MCTRL Motor temperature higher than fixed limit temperature ?  C0583  054 OH4 MCTRL Heat sink temperature higher than variable limit temperatur (C0122) ?  C0582  057 OH7 MCTRL Motor temperature higher than variable limit temperature (C0121) ?  C0584  058 OH8 MCTRL Motor temperature via inputs T1/T2 too high   ? C0585  061 CE0 AIF Communication error in AIF module PLC   ? C0126   CAN communication error 062 CE1 CAN1 CAN1_IN (monitoring time can be set under C0357/1)   ? C0591   063 CE2 CAN2 CAN2_IN (monitoring time can be set under C0357/2) C0592 064 CE3 CAN3 CAN3_IN (monitoring time can be set under C0357/3) C0593 065 CE4 CAN CAN BUS-OFF status (too many faulty telegrams received)   ? C0595   066 CE5 CAN CAN time-out (gateway function)   ? C0306  070 U15 internal Undervoltage of internal 15 V voltage supply ?   071 CCr int