Cisco7018---机架标准.pdf

INSTRUCTIONS CM385 ? Panduit Corp. 2008 FOR TECHNICAL SUPPORT /resources/install_maintain.asp NET-ACCESS Cabinet for Cisco Nexus 7018 Switch CN3 CN7018-EXT CNAE7018 Page 1 of 8 CNPS7018 Component Guide (1) Base Cabinet (2) Cable Management Finger Kits (1) Hardware Kit (2) #12-24 Threaded Equipment Rail Sets (2) Top Side Extensions (2) Top Front/Rear Extensions (2) Bottom Door Shoe Extensions (2) Bottom Side Extensions (1) Inlet Duct Assembly (2) Side Panels (2) Lower Horizontal Supports (2) Split Door Sets (1) Exhaust Duct Assembly (1) Bottom Duct Assembly For installation instructions for the CN3 cabinet, please reference instruction sheet CM317B. (2) Vertical Side Supports (1) Hardware Kit (5) Mounting Brackets (1) Hardware Kit INSTRUCTIONS CM385 For Technical Support: /resources/install_maintain.asp Page 2 of 8 Installation of Top Side Extensions Top Cap Extension Assembly Installation of Top Front and Back Extensions Install (2) top side extensions, using (2) 5/16” serrated flange lock nuts on each extension (there are pre-installed 5/16” press-studs in side extensions). Remove knock-out feature from original top cap if necessary. Do not tighten side extensions until front and rear extensions are mounted and aligned with original top cap. Top front and back extension installation is shown at the bottom of this page. Remove Knock-outs (if necessary) Side Extensions 5/16” Serrated Flange Lock Nut Attach (2) top front and rear extensions, using (4) #10-32 nuts and (4) #10 lockwashers per extension piece (there are (4) pre-installed #10 press-studs in each extension). Align all top extension parts, leaving a minimal gap between side and front/rear parts. Secure side extensions by tightening (4) 5/16” serrated flange lock nuts. Assembled Rear Extension Front Extension See Detail View Assembled #10-32 Nut #10 Lockwasher INSTRUCTIONS CM385 For Technical Support: /resources/install_maintain.asp Page 3 of 8 Installation of Front and Back Bottom Door Shoe Extens