COMMON-10-0702-001.pdf

INTEQ Technical Publications Group techpubs@ Common Procedures Repair Maintenance Manual TSS Removal and Installation COMMON-10-0702-001 Rev. A / June 2006 Confidential Revision History All revisions to the document should be listed here. Minimally, entries should include a description of the revision, approver of the revision, and the date. All revisions to this document must have an associated Document Change Request (DCR). Changes cannot be made to this document without an approved DCR. Rev DCR Amendment Detail Approval Date A -- Initial release L. Heuermann 06/2006 This manual is provided without any warranty of any kind, either expressed or implied. The information in this document is believed to be accurate. However, INTEQ will not be liable for any damages, whether direct or indirect, which result from the use of any information contained herein. ?2006 Baker Hughes Inc. COMMON PROCEDURES RM MANUALCONFIDENTIAL 7-1 COMMON-10-0702-001 REV. A / JUNE 2006 Uncontrolled when printed Section 7 TSS REMOVAL AND INSTALLATION Use this procedure as a guide while removing and installing the Tapered Stabilizer Sleeve (TSS) on the subs. REFERENCE DOCUMENTS Tool Size Drawing or Document Number Description Kit, TSS (OnTrak 6.75) Stabilizer Clamp Sleeve ID 170 Stabilizer Clamp Sleeve ID 174 8.1/4 Clamp-On Stabilizer, Non-Magnetic, (6.3/4 subs) 6-3/4 10000006524 Rework, sub 6-3/4 for TSS Kit, TSS (OnTrak 8.25) Stabilizer Clamp Sleeve ID 209 10-5/8 Clamp-On Stabilizer, Non-Magnetic, (8-1/4 subs) 8-1/4” 10000007916 Rework, sub 8-1/4 for TSS Kit, TSS (OnTrak 9.5) Stabilizer Clamp Sleeve ID 240.5 11-1/2 Clamp-On Stabilizer, Non-Magnetic, (9-1/2 subs) 9-1/2 10000007256 Rework, sub 9-1/2 for TSS SPECIAL TOOLS AND EQUIPMENT Tool Size Part Numb