HN 1461_1998.pdf

A.C.N. 006 893 232 Holden Limited Engineering Department M ATERI AL SPECI F I CATI O N NUMBER SHEET RELEASE REVISION : : : : HN 1461 1 of 9 August 1976 May, 1998 NAME: STEEL SHEET, STRIP AND PLATE THIS DOCUMENT MUST NOT BE REPRODUCED. IF USED IN RELATION TO THE COMPANY’S PRODUCTS THE RECIPIENT IS RESPONSIBLE TO CONFIRM THE DOCUMENT ISSUE DATE IS STILL VALID. FORM : I:\LABRTORY\FORMSTD\MATSPEC.DOC 1. GENERAL This specification covers the requirements for hot rolled low carbon and cold rolled low carbon steel sheet, strip and plate suitable for the manufacture of automotive parts. 2. APPLICATION Grades covered by this specification are for general use. Cold rolled steels are used for the majority of body parts to achieve closer thickness tolerances and surface finish requirements. 3. REFERENCE SPECIFICATIONS 3.1 Australian Standards, AS 1594 - 1997 ‘Hot Rolled Steel Flat Products’ AS 1595 - 1981 ‘Cold Rolled Unalloyed Low Carbon Steel Sheet and Strip’ AS 1391 - 1991 ‘Methods for Tensile Testing Metals’ 3.2 Japanese Industrial Standards, JIS G3131-1996 ‘Hot Rolled Mild Steel Plates, Sheets and Strip’ JIS G3141-1996 ‘Cold Reduced Carbon Steel Sheets and Strip’ 3.3 Holden HN Specifications HN1623 Single Layer Enamel Topcoat HN1673 Base Coat / Clear Coat Enamel Topcoat (Acrylic / Acrylic) HN1643 Base Coat / Clear Coat Enamel Topcoat (Polyester / Acrylic) HN1663 Immersion Zinc Phosphate (Substrates: Steel And Zinc Coated Steel) Referenced in Section 8.0 of this specification for materials used for parts painted in the Holden production paint system. Copyright Holden Limited Provided by IHS under license with HOLDEN Not for ResaleNo reproduction or networking permitted without license from IHS - - ` ` ` ` ` - ` - ` , , ` , , ` , ` , , ` - - - A.C.N. 006 893 232 Holden Limited Engineering Department M ATERI AL SPECI F I CATI O N NUMBER SHEET RELEASE REVISION : : : : HN 1461 2 of 9 August 1976 May, 1998 NAME: STEEL SHEET, STRIP AND PLATE THIS DOCUMENT MUST NOT BE RE