MAX17003ETJ+T,MAX17004ETJ+T,MAX17004ETJ+,MAX17003ETJ+,MAX17003ETJ+T, 规格书,Datasheet 资料.pdf

For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642, or visit Maxim’s website at . General Description The MAX17003/MAX17004 are dual step-down, switch- mode, power-supply (SMPS) controllers with synchro- nous rectification, intended for main 5V/3.3V power generation in battery-powered systems. Fixed-frequen- cy operation with optimal interleaving minimizes input ripple current from the lowest input voltages up to the 26V maximum input. Optimal 40/60 interleaving allows the input voltage to go down to 8.3V before duty-cycle overlap occurs, compared to 180° out-of-phase regula- tors where the duty-cycle overlap occurs when the input drops below 10V. Output current sensing provides peak current-limit pro- tection, using either an accurate sense resistor or using lossless inductor DCR current sensing. A low-noise mode maintains high light-load efficiency while keeping the switching frequency out of the audible range. An internal, fixed 5V, 100mA linear regulator powers up the MAX17003/MAX17004 and their gate drivers, as well as external keep-alive loads. When the main PWM regu- lator is in regulation, an automatic bootstrap switch bypasses the internal linear regulator, providing current up to 200mA. An additional adjustable linear-regulator driver with an external pnp transistor may be used with a secondary winding to provide a 12V supply, or powered directly from the main outputs to generate low-voltage outputs as low as 1V. Independent enable controls and power-good signals allow flexible power sequencing. Voltage soft-start grad- ually ramps up the output voltage and reduces inrush current, while soft-discharge gradually decreases the output voltage, preventing negative voltage dips. The MAX17003/MAX17004 feature output undervoltage and thermal-fault protection. The MAX17003 also includes output overvoltage-fault protection. The MAX17003/MAX17004 are available in a 32-pin, 5mm x 5mm, thin QFN package. The exposed backside