SAE_USCAR2_Rev3_2001汽车电子连接器性能标准答题.doc

PERFORMANCE STANDARD FOR AUTOMOTIVE ELECTRICAL CONNECTOR SYSTEMS 车用电子连接器系统性能标准 SAE/USCAR-2 Issued August 1997 REVISION 3 Revised April 2001 ***WARNING警告*** No electrical connector, terminal, or related component may be represented as having met USCAR /EWCAP specifications unless conformance to all applicable requirements of this specification have been verified and documented. At least the minimum applicable sample size set forth in each test must have been tested with no sample in the entire group tested failing to meet all applicable Acceptance Criteria for that test. All required verification and documentation must be done by the supplier of the part or parts . If testing is performed by another source, it does not relieve the primary supplier of responsibility for documentation of all test results and for verification that all samples tested met all applicable Acceptance Criteria. 如果没有完全符合所有USCAR/EWCAP的要求并作验证确认和文文件记录，任何电子连接器、端子或相关零件都不能宣称已经符合USCAR/EWCAP的规格。至少要达到最少样品数量要求并且其中所有样品都必须通过该测试所对应的“接受标准”。所有要求的确认和文书记录必须由零件供货商完成。如果测试由其它单位完成，供货商并不能豁免记录所有零件测试结果并符合相应“接受标准”的责任。 1.0 SCOPE适用范围 Procedures included within this specification are intended to cover performance testing at all phases of development, production, and field analysis of electrical terminals, connectors, and components that constitute the electrical connection systems in low voltage (0 - 20 VDC) road vehicle applications. These procedures are only applicable to terminals used for In-Line, Header, and Device connector systems. They are not applicable to Edge Board connector systems, 20 VAC or DC, or to eyelet type terminals. 本规范中的程序意在包括端子、连接器及其部件（这些端子、连接器及其部件构成路面交通工具直流0-20伏低压电子连接系统）的在所有研发、生产和现场分析中的性能测试标准。这些规程只适用于线路中连接器系统中、针类连接器系统中和设备连接器系统中的端子，但不适用于“边板连接器系统”（Edge Board connector systems），交/直流20伏，或针孔（eyelet）型的端子。 Note that this specification does not cover the mechanical assist portions of connect