SiemensTubeCompatibilityTable.docVIP

CPI Canada Inc X-Ray Tube Stator Compatibility Tables Use and disclosure is subject to the restrictions on the title page of this CPI document. X-Ray Generator Service Manual Supplement 746026 Rev. V1 Page  PAGE 3 Note: This section only covers siemens tube. please refer to your service manual and X-RAY GENERATOR SERVICE MANUAL supplement 746026 for more DETAILED informatioN. SUPPLEMENT X-RAY TUBE STATOR COMPATIBILITY TABLES LOW SPEED STARTER TUBE SELECT TABLE (cont) TABLE 1: TUBE TYPES (LOW SPEED STARTER)TUBE TYPE (HOUSING)TUBE TYPE (INSERT)RUN VOLTAGE (Indico only)BOOST TIME (Indico only)GENER-ATORSHIFT CAP.LSS PART #Siemens Opti 150 “S” stator (14/18 ?)20/4030/52R 52 VAC2.5 secIndico 10045 ?F732752-02CMP 20040 ?F903836-01Siemens (SXVT)RAY (1-phase only)(20/50 ? stator)RAY-6_1RAY-8(S)_1RAY-12(S)_1 RAY-14(S)_173 VAC1.5 secIndico 10033 ?F732752-00CMP 20030 ?F903836-00 3.0 DUAL SPEED STARTER TUBE SELECT TABLE The Dual Speed Starter (DSS) synthesizes its output frequencies independently of the line frequency and will operate all tubes at 60/180 Hz, unless a particular tube only has published ratings to operate at 150 Hz. In this case, the starter will output 50/150 Hz when set for these tubes. Unless indicated otherwise within Table 2, setting the switches to the code indicated for the applicable Tube Type selects all required operating parameters. The Dual Speed Starter part number corresponds to the AC line voltage and the configuration of phase-shift capacitors installed. Reference notes are provided at the end of Table 2. Tube operating parameters for each switch code are contained in Table 3 for reference. TABLE 2: TUBE TYPES (HIGH SPEED STARTER)TUBE TYPE (HOUSING)TUBE TYPE (INSERT)CODE Switches 15OPERATING NOTES (SEE TABLE 3 FOR OPERATING PARAMETERS)OUTPUT FREQ.H.S. SHIFT CAP.L.S. SHIFT CAP.INDICO 100 DSS PART NO.**CMP 200 DSS PART NO.**Siemens Biangulix “S” stator (1-