EP132WSETUP.doc

E-P132-W Quick Installation Guide E-P132-W is combined ACCESS POINT (WX-1590) with E-P132 Module . Please refer to the quick installation guide of wx-1590 and the manual of E-P132 Connect RJ-45 cable between HUB and E-P132-W (LAN-1 or LAN-2) E-P132-W Power On Install CONFIG UTILITY for WX-1590 Access Point (select SNMP soft) Run AP UTILITY from PC START menu To Change the IP of your PC to 192.168.5.XXX for you to modify the parameter of E-P132-W The default IP of E-P132-W is 192.168.5.100 FIND AP select the ACCESS POINT and press CONNECT Community : public Authority : Adminstrator Press OK If you wish to changt the IP , subnet mask , gateway Press SETUP – BRIDGE If you wish to modify parameters of SSID , AP Name operational mode PRESS SETUP – WIRELESS LAN – OPERATIONAL SETTINGS Select Operational Mode – Access Point Client For E-p132-W Select Network – KNOWNS BSSs to select access point to connect Select Access Point to connect and as Access Point Client Mode Select File to save the parameter to E-P132-W and Close Connection AP Disconnect RJ-45 Cable from E-P132-W and Power Off Power On E-P132-W for Restart Wait One minute for E-P132-W Auto-Connect to ACCESS POINT Select the directory ‘UTILITY’ of CONVERTER Run The ETM.EXE for it can find the IP of RS-232/422/485 TO TCP/IP CONVERTER You can change the IP domain same with pc and press CONFIG – Device-Settings for it can use IE Browser to enter the web-server of tcp/ip converter press login to enter and you can modify parameter Please see the MANUAL of CONVERTER FOR details