TVDomesticIISfrom17to42IIS040917Final.pptVIP

MODELS;Contents;Revision Status;1.0 Introduction 1.1. Scope This Incoming Inspection Standard shall be applied to TFT-LCD modules(hereafter called the LCMs) supplied by LG.PHILIPS (hereafter called the Supplier) to its Customer. 1.2. Incoming inspection Right The Customer shall have the right but not the obligation to conduct at its own cost and expense, an incoming inspection of the LCMs at the destination specified in the relevant B/L(Bills of Lading) in accordance with the LCMs specifications separately agreed upon and the inspection criteria set forth in this article. The Customer shall notify the Supplier in writing of the inspection results (acceptance or rejectance) in accordance with the said Incoming Inspection Standard within 40 days from the date of the B/L. In case no incoming batch inspection is being done at Customer side, individual rejects will be claimed within 40 days after receiving the goods in Customers’ factory. Details for the handling of rejects will be settled per region. Should the Customer fail to notify the results to Supplier within 40 days period, the right to reject the LCMs shall then lapse, and the said LCMs shall be deemed to have been accepted by the Customer. General warranty clauses will of course continue to be valid. 1.3. Handling Precautions - LCM Devices are made of fragile material such as Glass and plastic and may be broken or cracked if dropped it, so PLEASE handle them with care. - DO NOT press the area covered with PET or such materials. These are weak point of LCMs since of TCPs(Driver ICs) and PWBs. - PLEASE support the Bezel with your finger when connecting the interface cable. - Please DO NOT touch the surface of the Glass(Polarizer). - PLEASE wear the Wrist Strap when handling. Semiconductive devices are included in the LCMs and they should be handled with care to prevent any electrostatic discharge(ESD). - PLEASE